Startup and configuration
8099_en_02
PHOENIX CONTACT
2-3
4
EPA-to-EPA bridge: wait for configuration
Step 1 for establishing a direct connection (ad hoc) between two
EPAs. As long as the LED flashes, the module waits for a connection
request. After connection establishment the module accepts IP
address 10.0.0.99.
C
5
EPA-to-EPA bridge: connection establishment
Step 2 for establishing a direct connection (ad hoc) between two
EPAs. The module initializes connection to a module in mode 4 -
“Wait”. After connection establishment the module accepts IP address
10.0.0.100.
A+C
6
EPA-to-EPA bridge with PROFINET optimization:
wait for configuration
Step 1 for establishing a direct connection (ad hoc) between two
EPAs. As long as the LED flashes, the module waits for a connection
request. SafetyBridge transmission requires the web interface to be
switched off. After connection establishment the module accepts IP
address 10.0.0.99.
B+C
7
EPA-to-EPA bridge with PROFINET optimization:
Connection establishment
Step 2 for establishing a direct connection (ad hoc) between two
EPAs. The module initializes connection to a module in mode 6 -
“Wait”. SafetyBridge transmission requires the web interface to be
switched off.
After connection establishment the module accepts IP address
10.0.0.100.
A+B+C
8
UDP tunnel in an infrastructure: wait for configuration
Establishing a UDP tunnel between two EPAs. This requires the EPAs
to be connected to the WLAN already. After configuration the module
accepts IP address 10.0.0.99 and is configured as the tunnel end point
in the WLAN.
D
9
UDP tunnel in an infrastructure: connection establishment via
the wireless side of a WLAN
Establishing a UDP tunnel between two EPAs. This requires the EPAs
to be connected to the WLAN already. After configuration the module
accepts IP address 10.0.0.100 and is configured as the tunnel starting
point in the WLAN.
A+D
Table 2-1
Operating modes (Fortsetzung)
Mode
Description
LEDs
A
B
C
D
