Phoenix Contact ILC 330 Series, User Manual, Page: 28 / 96

ILC 330.../350...
28
PHOENIX CONTACT 6959_en_07
Mounting When mounting the Inline controller, proceed as shown in Figure 2-13:
• Disconnect the power to the station.
• Place the Inline controller onto the DIN rail from above (detail A) and push down
(detail B).
• Then attach all the electronics bases required to set up the station. Observe the
information provided in the aforementioned user manuals.
• Once all the bases have been snapped on, insert the connectors in the corresponding
bases.
First, place the front connector shaft latching in the front snap-on mechanism
(detail C1).
Then press the top of the connector towards the base until it snaps into the back snap-
on mechanism (detail C2).
Figure 2-13 Snapping on the Inline controller
Make sure that all featherkeys and keyways on adjacent terminals are securely
interlocked.
A
B C
C1
C2
6959B009