Phoenix Contact IB IL 24 PSDO 8-PAC, User Manual, Page: 99 / 112

7619_en_05 PHOENIX CONTACT
99 / 112
D Appendix: Checklists
The checklists listed in this section provide support during the planning, mounting, and elec-
trical installation, startup, parameterization, and validation of the IB IL 24 PSDO 8-PAC
module.
Archive the completed checklists to use as reference for recurring tests.
The checklists do not replace validation, initial start-up as well as regular testing by qualified
personnel.
The following section of a checklist shows an example of a completed checklist.
These checklists may be used as planning documentation and/or as verification to ensure
the steps in the specified phases are carried out carefully.
For more comprehensive checklists, please refer to the
UM EN INTERBUS-SAFETY SYS user manual.
Checklist . . .
Device type / Equipment identification IB IL 24 PSDO 8-PAC / BK20NA10
Version: HW/FW/FW 00/100/100 Date 2008-01-03
Editor John Smith Test engineer Jane Brown
Comment System XXX has been checked for engine hood production
No
.
Requirement (mandatory) Yes Comment
X . . .
No
.
Requirement (optional) Yes No Comment
Y . . .
Key:
Equipment identification Enter the device type and/or the equipment identification for the relevant device.
Version: HW/FW/FW Enter the hardware and firmware version of the device (see Section “Structure of the
safety module” on page 18).
Date Enter the date on which you began to fill in this checklist.
Editor Enter the names of the editor.
Test engineer Enter the name of the test engineer.
Comment Where necessary, enter a comment.
Requirement (mandatory) These requirements must be met for a safety application, in order to complete the relevant
phase using the checklist.
Requirement (optional) These requirements are optional. For points that are not met, please enter an appropriate
remark in the relevant field.