PSI-MODEMSHDSL/SERIAL
2-2
PHOENIX CONTACT
104275_en_c00
2.1
Mounting the module on a DIN rail
2.1.1
Mounting on a DIN rail (single device)
Figure 2-1
Mounting and removal (single device)
Mounting:
•
Place the device onto a grounded 35 mm DIN rail from above so that the upper housing
keyway hooks onto the top edge of the DIN rail (see Figure 2-1 A).
•
Holding the device by the housing cover, carefully push the device towards the mount-
ing surface.
•
Once the snap-on foot has been snapped onto the DIN rail, check that it is fixed secure-
ly.
Removal:
•
Use a suitable screwdriver to release the locking mechanism on the snap-on foot of the
•
Hold onto the device by the housing cover and carefully tilt it upwards.
•
Carefully lift the device off the DIN rail.
WARNING:
Only mount and remove the modem when the power supply is disconnected.
NOTE:
The DIN rail must be connected to PE to ensure safe operation.
A
101973A008
B