23
Your phone doesn’t work well in your car
A car contains many metallic parts that absorb electromagnetic waves which can affect the phone’s
performance. A car kit is available to provide you with an external antenna and enables you to make
and receive phone calls without handling the handset.
Note:
•
Check with the local authorities whether or not you are allowed to use the phone while driving.
Your phone is not charging
If the battery is completely flat, it might take several minutes of pre-charge (up to 5 minutes in some
cases) before the charging icon is displayed on the screen.
The picture captured with the phone camera is not clear
Make sure that the camera lens on both sides is clean.
Trademark Declaration
Specific Absorption Rate Information
International standards
THIS MOBILE PHONE MEETS THE INTERNATIONAL RECOMMENDATIONS FOR EXPOSURE
TO RADIO WAVES
Your mobile phone is a radio transmitter and receiver. It is designed and manufactured not to exceed
the limits for exposure to radio frequency (RF) energy defined by the international standards. These
recommendations have been established by the International Commission on Non-Ionizing Radiation
Protection (ICNIRP) and, the Institute of Electrical and Electronics Engineers (IEEE) that forecast a
substantial safety margin for assuring the protection of all persons, regardless of age and health.
The exposure recommendations for mobile phones use a measurement unit known as the Specific
Absorption Rate (SAR). The SAR limit recommended by the ICNIRP for the mobile phones used by
the general public is
2.0W/kg averaged over ten grams of tissue and, is 1,6W/kg averaged over one
gram of tissue
by IEEE Std 1528 for the head.
Tests for SAR have been conducted using recommended operating positions with the mobile phone
transmitting at its highest certified power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR levels of the mobile phone while
operating are generally below the maximum SAR value. This is because the phone is designed to
operate at multiple power levels so as to use only the power required to reach the network. In
general, the closer you are to a base station antenna, the lower the power output.
While there may be differences between the SAR levels of various phones and at various positions,
they all meet the international protection standards for exposure to radio waves.
The highest SAR value for this Philips Xenium X333 model phone when tested for
compliance against the standard was 0.633W/kg for ICNIRP recommendation.
T9
®
T9
®
is a registered trademark of Nuance Communications, Inc..
JAVA
JAVA is a trademark of Sun Microsystems, Inc.
Bluetooth™
Bluetooth™
is a trade-mark owned by telefonaktiebolaget L M Ericsson,
Sweden and licensed to Philips.
Philips
PHILIPS and PHILIPS’ Shield Emblem are registered trademarks of Koninklijke
Philips Electronics N.V. manufactured by Shenzhen Sang Fei Consumer
Communications Co., Ltd. Under license from Koninklijke Philips Electronics
N.V..
