Philips WP3892, User Manual

Page: 11 / 144

11
D
Note:
If the water supply stops while the
appliance dispenses in manual mode, the
pure water dispenser switches to AUTO
mode
f
.
If you want to program the pure water
dispenser to dispense at a later time
(when water supply resumes), press the
LITRES button to set a water quantity.
The display shows the set quantity.
The pure water dispenser is now ready
to dispense the set quantity automatically
once the water supply resumes.
6.0.2 Purifying in AUTO mode
1
Press the power-on button on the pure
water dispenser. Wait until the dispense
button
d
flashes.
2
Press the MODE button
The pure water dispenser goes into AUTO
mode
f
.
The dispense button
d
goes out and
the display flashes.
3
Press the LITRES button to set the desired
water quantity.
If you press the button briefly, the quantity
increases by 0.2 litres each time you press the
button.
If you press and hold the button briefly, the
quantity increases quickly.
Once you have set the quantity, the dispense
button
d
flashes.
4
Press the dispense button
d
The appliance dispenses purified water.
The display counts down as the water is
dispensed (i.e. the display shows the amount
of water still to be dispensed).
The pure water dispenser automatically
stops when it has dispensed the set quantity.
The display retains the previously set
quantity so that you can fill multiple
containers of the same capacity.
To cancel/reset the existing setting, either
press the MODE button (to switch to manual
mode) or press the power-on button to
switch off the dispenser.
•
•
•
•
•
•
•
•
•
•
6 Using the appliance
1
Open the tap connected to the pure water
dispenser.
2
When you use the appliance for the first
time or if you have not used the appliance
for 2 days or more, use the PureFlush
function. See section ‘PureFlush’ in this
chapter.
6.0.1 Purifying in manual mode
1
Press the power-on button on the pure
water dispenser
All indicators flash on and off.
The power-on indicator
y
goes on.
The display goes on.
WP3893 only: If mains power is available,
the battery indicator
z
lights up green.
If there is no mains power available, the
battery indicator lights up red. During
charging, the battery indicator flashes
green. When the battery is almost empty,
the battery indicator flashes red.
The pure water dispenser checks the water
availability, the filter and the UV lamp.
As the purification process proceeds, first
the red segment of the purification stage
indicator
e
lights up, followed by the yellow
segment. When the purification process
is finished (after 30 seconds), the green
segment lights up.
The dispense button
d
flashes (default
mode= manual).
2
Press the dispense button
d
The pure water dispenser dispenses water.
The display shows the quantity of dispensed
water and the dispense button lights up
green.
3
To stop the water flow, press the dispense
button
d
again.
The dispense button flashes and the
appliance is ready to dispense again.
•
•
•
•
•
•
•
•
•
EN
g
lI
Sh