Automatic alarm termination
After 3 minutes the monitor returns to the status it was
in before the alarm was sounding.
If the automatic camera sequence was active, it will be
continued. However, the corresponding camera LED
remains flashing for as long as the alarm line is active
(alarm detector is still active) or the camera line is still cut.
Premature (within 3 minutes) alarm
termination
The alarm output (fig. B-5) will be de-activated by
switching off the alarm. See alarm programming above.
Pressing any key on the control panel of the monitor
within 15 seconds will end the alarm sound only.
Alarm priority
A new alarm always gets priority. The monitor will always
switch to the camera of the last-received alarm but the
LED(s) of each previously received alarm blink faster.
Tips for maintenance
Ventilation
Avoid overheating the system monitor by ensuring to it
that the ventilation openings on the top of the monitor
remain uncovered. Do not place the monitor in the
immediate vicinity of a source of heating.
Cleaning
You can clean the system monitor with a moist, fluff-free
cloth or chamois leather cloth.
The outside of the camera can be cleaned with a moist,
fluff-free cloth or chamois leather cloth.
When cleaning the objective a special lens cleaning cloth
should be used. Do NOT use cleaning fluids
that contain alcohol, methylated spirit, ammonia, etc..
Avoid direct contact with water.
Warning:
The back of the monitor should only be removed
by a qualified service technician.
g
5
