Case a: Cables’ route is above the ceiling
Case a: Remove the mounting plate by pushing the side tabs.
Drill two holes (
≥
3mm [0.19-inch]) for camera mount; and one (1) go-through hole
(
≥
8mm [0.31-inch]) for cables entry. (See template).
Case b: Cables’ route is on the wall
Case b: Remove the mounting plate by pushing the side tabs.
Drill two holes (
≥
3mm [0.19-inch]) for camera mount only. (See template).
1.
Route the cables through the mounting plate, and then mount the plate using
the two supplied screws.
Locate cable into the appropriate routing clip
a. For through connection (ceiling mount).
b. For direct connection (wall mount).
2.
Locate the Dome camera onto the mounting plate.
3.
Connect the Dome camera to the system monitor.
4.
Connect the system monitor to the mains.
5.
Switch on the mains power switch.
The monitor will check the system. After a short time the Dome camera image
will appear on the monitor screen.
6.
If necessary adjust contrast /brightness and/or color (See the View Settings
5
Eng
Fig. 1
120º Horz; 120º Vertical;
360º Rotation
Push in
Cable entry
Mounting
Slots
minidome ml1.qxd 21-Oct-01 11:38 AM Page 5
