Philips Vari-lite VL3015LT, Service Manual

Page: 134 / 184

VARI
❋
LITE - VL3015LT S
POT
L
UMINAIRE
S
ERVICE
M
ANUAL
1 1 6 0 2 . 9 6 9 8 . 0 0 1 0 0
Tilt Motor Assembly (continued)
Figure 3-30: Tilt Motor Assembly
0.239"
5
6
7
14 (x2)
11 (x4)
12 (x2)
Note : Vari-Lite recommends that this assembly be replaced as a complete assembly. Although you can replace only the motor, the pulley (Item 2) is bonded
to the motor shaft during assembly and cannot be removed intact. If you order a replacement motor (Item 4), also order the pulley (Item 2). Contact Vari-Lite
Customer Service for installation information.
Step 1. Apply one drop of Loctite 603 to motor shaft.
Step 2. Install drive pulley on motor shaft using twisting
motion to insure coverage of shaft with loctite.
Step 3. Do not allow Loctite to drip into motor bearing.
Step 4. Set pulley height as shown above.
Step 5. Apply Loctite 242 to pulley set screws. Insure set
screws are aligned and tightened on flat sides of
motor shaft.
Pulley Height Detail & Installation
Detail A
5a
5c (x2)
5b
Pressure-Sensitive Adhesive
See Detail A
3
* As required to set proper height.
10 (x2)
13 (x2)
2
9 (x4)
15 (x6)
4 (x2)
1 (x2)
8 (x2)