Philips TPE1.1U LA Service Manual Download Page 80

Page: 80 / 104

TPE1.1U LA

9. Trouble Shooting

Symptoms

Ghost or double
images
No power

No picture

No picture and power
switched on

Picture position
adjustment

No photo, music or
video play or in poor
quality only
No sound

Good sound but poor
color or no picture
Snowish picture and
noise
Television not
responding to
remote control

Control of accessory
devices

The software will not
install

Standby

After improper
shutdown
Miscellaneous

Items to Check and Actions to follow

This may be caused by obstruction to the antenna due to high rise buildings or hills.
Using a highly directional antenna may improve the picture.
Check that the TV s AC power cord is plugged into the mains socket.
Unplug the television, wait for 60 seconds. Then re-insert plug into the mains socket
and turn on the television again.
Check antenna connections at the bottom of the TV to see if they are properly connected to the TV.
Possible broadcast station trouble. Try another channel.
Adjust the contrast and brightness settings. Try another auto picture setting.
Check the Closed Captions control. Some TEXT modes could block the screen.
Check if you selected the correct AV source.
Your TV has a protective mode in case there is too much heat build-up. Check the
clearance around the vents of the device to be certain there are no blocking walls or
cabinets which would limit the air flow.
When displaying a High Definition signal from the YPbPr inputs or HDMI input, if necessary, you can
adjust the picture position to the center of the screen with the cursor left/right or up/down buttons on
the remote control. This may be needed due to slight differences in output signals from different brands
and types of HD sources boxes.
Notes: Most High Definition receiver boxes also have picture-positioning controls in their menu
systems. If the TV cursor controls run out of range before the picture is correctly positoned, the
receiver box controls will need to be adjusted.
Check if the source complies with a supported code.

Increase the VOLUME.
Check that the TV is not muted, press the MUTE button on the remote control.
When no signal is detected, the TV automatically switches off the sound. This is proper
operation and does not indicate a malfunction.
Adjust the contrast, color, tint and brightness setting. Try another auto picture setting.

Check the antenna connection.

Check whether the batteries are working. Replace if necessary.
Clean the remote control sensor lens on the monitor.
Operating range between TV and the remote control should not be more than approximately twenty feet.
You can still use the buttons on the right side of your TV.
Check if the remote control is in the correct mode.
The infrared signals of the screen may influence the reception sensibility of other peripherals Solution:
replace the batteries of the remote control of other devices. E.g. keep away a wireless headphone from
within a radius of approximately four feet.
Possibly the operating system is wrong. Go to www.usasupport.magnavox.com to see which operating
systems are supported.

Your TV consumes energy less than 1w in the standby mode.
Energy consumption contributes to air and water pollution.
If your TV has been shutdown in an improper way (e.g. power drop, power cord plug out), starting up the
TV again will take a longer time than usual.
See Extras, Specifications on this CD.