Philips TE2.1E AA, Service Manual

Page: 6 / 44

TE2.1E AA
EN 6
4. Mechanical Intructions
Disassembly procedure is explained as below. Before disassembling the TV set please
read the safety instructions and warning parts of the service manual.
• Turn off TV and plug the mains out
• Remove screws (10 pieces) to dismount the back cover
• Disconnect the following sockets to take the chassis out ;
¾
Deflection cables
¾
Degaussing coil
¾
Speaker cable
¾
Power cable
• Remove the ground cable localised between tube module and mass wire.
• Remove the CRT drive module from picture tube.
• Remove anode cable localised on the picture tube.
• Slide out the chassis through the guides (no screws, straps or other fixing).
Please follow the assembly instructions explained below;
• Before inserting the chassis into guides, check the control buttons in front of the
chassis. In case of misplacement of control buttons place them into correct position.
• Slide the chassis into guides until the connection cables could be reached to their
sockets.
• Plug in the power cable socket to KP03.
• Plug in the degauss cable socket to KP02.
• Plug in the speaker cable socket to KA04.
• Place the CRT drive module on picture tube.
• Slide the chassis completely on its place. Be careful about control buttons.
• Plug in the deflection cable socket to KD02 and KD01.
• Place the anode cable to picture tube. Be careful about high voltage!
¾
CRT drive module must be grounded via mass cable.
• Place the back cover back to its place.(10 screws)
• Plug the mains in.
• Turn on the TV.