Philips SWW1810, User Manual

Page: 12 / 60

12
Establish the link between the
transmitter and receiver
] ^ " _`;
the signal link between the two units are
established. Normally, it takes around 15-20
seconds for the link to establish successfully.
Select the source on the transmitter
Press the source buttons on the remote
control, transmitter or receiver until you see the
available video from your device.
Tip
For information on the LED indicator status, see the
section on ‘LED indicator status of the transmitter’.
LED indicator status of the
transmitter and receiver
Power
LED Source
LED Mode and status
Solid
red Off Standby mode: it is a
power-saving mode
Flashing
blue Flashing
blue Start up in progress: It takes
15-20 seconds.
Flashing
blue Flashing Searching available channels:
It occurs when the link
cannot establish over 80
seconds after initialization.
Solid
blue Flashing
# On mode but without
input from the source
device
Solid
blue Flashing
slowly On mode with
unrecognized video format
Solid
blue Solid
blue On mode with recognized
video format
Activate the wireless link
Switch on the transmitter and
receiver
In standby mode, a red power LED displays on
the transmitter and receiver. You can then turn
on the transmitter and receiver in the following
ways:
Press on the remote control.
»
Both the transmitter and receiver are
turned on.
Press on the transmitter and receiver.
EN
UYYAAWOA'0KPFF