4
EN
5
EN
2
Getting started
2.1 Inserting the batteries
•
Insert 2 AAA type batteries,
noting the + and -
configuration in the battery
compartment.
Note
When replacing the batteries, all user settings will be
retained in the remote control memory for 5 minutes.
2.2 Setting up the universal remote control
The example below instructs you how to set up your
universal remote controls for your TV.
You can repeat the same steps for other devices (STB, DVD
player/recorder and VCR) which you want to operate, using
the SRP4004.
The remote control can be set up to operate any 4 of the
following devices:
Device name
Description
TV
Traditional TV, flat screen TV and
projection TV, TV part of TV / VCR, TV /
VCR / DVD and TV / DVD combos
STB
Cable box, satellite receiver, Digital
Video Broadcasting Terrestrial device
(DVB-T), Internet Protocol TV
(IPTV), Free To Air TV, High Definition
Television decoder (HDTV)
DVD
DVD player / recorder (DVDR), DVD /
Hard Disk Drive combination (DVDR-
HDD), Blu-Ray player, High Definition
DVD player (HD-DVD), DVD part of
TV / DVD, TV / VCR / DVD and VCR /
DVD combos
VCR
Video cassette player / recorder, VCR
part of TV / VCR, TV / VCR / DVD and
VCR / DVD combos
Example: setting up the universal remote control to
operate your TV:
1
Switch ON
the TV manually or use the original remote
control for this. Tune to channel 1.
2
Press and hold
the
device selection button
for 5 seconds
until the red
Setup LED lights up.
The remote control is now
in setup mode.
3
Look up the 4-digit
code for your brand in the
brand list at the back of this
user manual.
A four-digit code is shown
for each brand.
Use the digit buttons to
enter the code for your
brand.
• If the red Setup LED
turns off, an invalid code
was entered. In this case,
try again.
4
Aim the remote control at
the TV.
Press and hold
the
button. Release it
immediately
as soon the TV
switches off.
• This step normally
takes between 5 and 60 seconds. In extreme
circumstances this step can take up to 15 minutes.
5
Switch ON
the TV.
Try out the buttons you
need for operating it. Try, for
example, if the
- CH +
and
digit buttons function
properly.
• If a button does not work as expected,
press and hold
that button. Release it
immediately
as soon as it works.
For more information, see chapter
2.2.2
.
6
Press the device
selection button
twice
to
finish setup.
•
When no button is
pressed for 5 minutes
or more, the remote
control will exit setup
mode, automatically saving all your settings.
Getting
star
ted
English
5 sec.
5 - 60 sec.
5-60 SEC.
2 x
