Philips Sonicare EasyClean HX6511/35, Manual

Page: 9 / 140

- The battery charge indicator shows the approximate remaining
battery charge (Fig. 3).
- Solid green light: 50-100%
- Flashing green light: 5-49%
- Flashing green light and 3 beeps after the brushing cycle: less than 5%
and toothbrush has to be recharged.
Note: To keep the battery fully charged at all times, you may keep your
Sonicare on the charger when not in use. It takes at least 24 hours to
fully charge the battery.
Using the appliance
1 Wet the bristles and apply a small amount of toothpaste.
2 Place the toothbrush bristles against the teeth at a slight angle
towards the gumline (Fig. 4).
3 Press the power on/off button to switch on the Sonicare.
4 Apply light pressure to maximise Sonicare’s effectiveness and let
the Sonicare toothbrush do the brushing for you. Do not scrub.
5 Gently move the brush head slowly across the teeth in a small back
and forth motion so the longer bristles reach between your teeth.
Continue this motion throughout the brushing cycle.
Note: To make sure you brush evenly throughout the mouth, divide your
mouth into 4 sections using the Quadpacer feature (see chapter ‘Features’).
6 Brush each section for 30 seconds for a total brushing time of 2
minutes. Start with section 1 (outside top teeth) and then brush
section 2 (inside top teeth). Continue with section 3 (outside bottom
teeth) and inally brush section 4 (inside bottom teeth). (Fig. 5)
7 After you have completed the 2-minute brushing cycle, you can
spend additional time brushing the chewing surfaces of your teeth
and areas where staining occurs. You may also brush your tongue,
with the toothbrush switched on or off, as you prefer (Fig. 6).
ENGLISH
9