5
EN
English
2 Get started
Note
Before using the headphones for the first time, charge the supplied
•
batteries for at least 10 hours.
•
Only use Philips rechargeable shortened sleeve NiMH batteries with your
headphones. Other types of rechargeable batteries cannot be charged
with this system.
•
AAA alkaline batteries can be used to operate the headphones, but
cannot be charged with this system.
If the volume of the audio source is insufficient, the transmitter
•
automatically turns off.
1
Install/Replace supplied batteries (Fig. B).
2
Install the antenna tube into the transmitter (Fig. C).
3
Power on the transmitter (Fig. D).
Red LED is on when audio source is connected.
»
Red LED blinks if no audio source is connected for two
»
minutes.
Red LED is off if no audio source is connected for four
»
minutes.
4
To charge the headphones, connect the charging cable with
the headphones (Fig. E).
Headphones: red LED is off during charge.
»
Transmitter: green LED is on during charge and is off when
»
headphones are fully charged.
When one headphone is during charge, another one can still
be used.
Transmitter: both red and green LED are on.
»
5
Power on the headphones and red LED is on (Fig. F).
6
Connect the audio device with the transmitter (Fig. G).
Red LED is on when audio source is connected.
»
Tip
If there is interference, tune the transmitter and the headphones to the
•
same channel (Fig. H).
