switch on the glasses and then press the
Player 1/2
key.
• If the LED light is orange and lits continuously for 2 seconds,
the glasses are set for player 1.
• If the LED light is orange and blinks, the glasses are set for
player 2.
For more information, press
Keywords
and look up
Two-
player gaming
.
Replacing the batteries
To replace the battery of the 3D glasses PTA508, unscrew the
small battery lid and replace the battery: type CR2032 (3V).
Make sure the + side of the battery is visible. Replace the lid and
fix it with the screw.
To replace the battery of the 3D glasses PTA509, PTA51, press
the small knob on the battery lid and slide the lid up to open.
Replace the battery: type CR2032 (3V). Make sure the + side of
the battery is visible. Replace the lid and slide it down until it
clicks.
Warning
• Do not ingest battery, chemical burn hazard
• This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe internal
burns in just two hours and can lead to death.
• Keep new and used batteries away from children.
• If the battery compartment does not close securely, stop using
the product and keep it away from children.
• If you think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical attention.
• Danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type.
For Passive 3D sets
When a 3D programme is shown on screen, simply put on the
3D glasses to watch the programme in 3D.
Recommended viewing height
For best picture quality, when watching passive 3D, your eyes
should be level with the centre of the screen.
13.4
Care of the 3D glasses
• Do not use cleaning chemicals containing alcohol, solvent,
surfactant, or wax, benzene, thinner, mosquito repellent or
lubricant. Using these chemicals can cause discoloration or
cracks.
• Do not expose the 3D glasses to direct sunlight, heat, fire or
water. This may result in a product malfunction or fire.
• Do not drop, bend or apply force to the lenses of the 3D
glasses.
• Use a clean soft cloth (microfiber or cotton flannel) to clean
the lenses to avoid scratching them. Never spray cleaner directly
onto the 3D glasses. This may damage the electronics (for
Active 3D glasses).
13.5
Watch 3D
To experience the best 3D effect while you watch 3D
programmes:
• Sit at a distance that is at least three times the width (w) of
the TV screen.
• Do not sit more than 6m away.
3D switching
The first time a 3D signal is detected, you can set your
preference on how to start 3D in the future.
• To switch to 3D automatically, select
Automatic
.
• To show a notification first, select
Notification only
.
• To never switch to 3D, select
Never
.
You can still change this preference in
>
Setup
>
TV settings
>
3D
>
Switch to 3D
.
Start 3D
When the TV switches to 3D or when a notification is shown
that 3D is available, put on your 3D glasses.
If the TV cannot detect the 3D signal (the 3D signal tag is
missing), the 3D programme is shown as a double image on
screen. To switch to 3D, adjust the 3D settings and select Side
by side or Top / bottom according to the double image
positions.
Stop 3D
To stop watching 3D, press
, select 3D settings and select Off.
3D is switched to 2D when you switch to another channel or
connected device.
2D to 3D conversion
You can convert any 2D programme to watch it in 3D.
1 -
Press
.
2 -
Select
Picture and sound
>
3D settings
>
2D to 3D
conversion
.
To adjust the 3D depth...
1 -
Press
.
2 -
Select
Picture and sound
>
3D effect
.
3 -
Select an option, then press
OK
.
To switch off 2D to 3D conversion...
1 -
Press
.
2 -
Select
Picture and sound
>
3D settings
>
2D
, then press
OK
.
Note: If you switch to another activity, the conversion stops.
52
