3
Press the two digits key.
– The green LED goes out.
4
Press key 1 and count the number of times the green LED
flashes. This is the first digit of the 4-digit code. (No
flashes means the digit is zero.)
5
Press key 2 and count the number of flashes for the second
digit.
6
Press key 3 and count the number of flashes for the third
digit.
7
Press key 4 and count the number of flashes for the forth
digit.
8
Note the code.
ADVANCED TIPS AND TRICKS
A d v i c e
Carefully read the complete procedure before starting!
Changing the device keys
With the mode selector it is possible to select 4 categories of
devices you want to operate. Each category (TV, VCR, SAT and
DVD) is meant to operate a specific group of equipment:
TV
VCR
SAT
DVD
tv
vcr
sat
dvd
cable
Once you have programmed the functions of a device in one
of the categories, it is not possible to program another device
in the same category. There is, however, a solution in case
you want to program two devices in the same category
(2 TV’s, VCR’s, etc.). The following example explains how.
EXAMPLE:
The SAT mode on this remote control is factory preset to
control many Philips satellite receivers. You can change the
SAT mode (or any mode) to operate another type of device.
The following example shows you how to use the SAT mode to
operate a second TV:
1
Press the mode selector key to select SAT and make sure
the second TV is switched on.
2
Press and hold keys 1 and 6 simultaneously -for about 3
seconds- until the green LED lights up.
3
On the keypad, press keys 9, 9 and 2.
4
Press the mode selector key to select TV mode.
5
Press key 1.
– The LED flashes twice to indicate successful set up.
That’s it!
Don’t forget to set up the SBC RU644 to operate this second
TV. See the section
Set-up for use
.
Instructions for use
English
6
Finland
1
2
3
4
1
9
9
2
1
6
TV
VCR
SAT
DVD
TV
VCR
SAT
DVD
XP SBC RU 644/05 27-08-2002 14:25 Pagina 6
