Mechanical Instructions
4.
4.
Remove the SSB as described earlier.
5.
Remove the PSU as described earlier.
6.
Remove the speakers as described earlier.
7.
Remove the IR/LED board as described earlier.
8.
Remove the WiFi module as described earlier.
9.
Remove the fixations screws that fix the metal clamps to
the front bezel. Take out those clamps.
10. Remove all other metal parts not belonging to the panel.
11. Lift the LCD Panel from the bezel.
When defective, replace the whole unit.
4.4
Assembly/Panel Removal(for 6801 series)
Instructions below apply to the 49PUG6801/12, but will be
similar for other 49"/55"/65"PUG6801 series models.
4.4.1
Rear Cover
Refer to
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1.
Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set.
2.
Remove the fixation screws [2], [3] and [4] that secure the
rear cover. Refer to
for details.
3.
Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
Note: Special for 65"PUG6801,there have screws [5] fixed on
the bottom side of rear cover,do remember to remove the
screws befor lift the rear cover from the TV. Refer to
for details.
Figure 4-13 Rear cover removal
Figure 4-14 Rear cover removal(for 65" only)
19921_102.eps
19923_101.eps
5
5
5
5
