Mechanical Instructions
4.
back to
4.3
Assy/Panel Removal
4.3.1
Rear Cover
Warning: Disconnect the mains power cord before removing
the rear cover.
Attention: For Ambilight sets, the leading edge cover has to be
removed.
It is mandatory to remove the leading edge cover and
disconnect the cables prior to removal of the rear cover!
See
and
for details.
1.
For sets equipped with Ambilight: remove the stand and
swivel block [1].
2.
Remove the leading edge hatch that covers the Ambilight
connector [2].
3.
Unplug the Ambilight connectors located underneath the
hatch [3].
4.
Lift the rear cover from the TV. Make sure that wires and
flat foils are not damaged while lifting the rear cover from
the set.
Figure 4-7 Rear cover removal Ambilight models -1-
Figure 4-8 Rear cover removal Ambilight models -2-
4.3.2
Ambilight units in Rear Cover
The Ambilight units are affixed in the rear cover and will
self-destruct upon removal.
Attention: it is of the utmost importance to remove all remains
of any adhesive that might be left on the inside of the rear
cover.
The new units come with double-sided adhesive tape. Ensure
a correct mounting to avoid uneven light emission of the units.
4.3.3
SSB
Refer to
for details.
Some SSBs have a dedicated LVDS connector, requiring
pressing two catches as indicated in the figure, before
removing the LVDS cable.
Figure 4-9 SSB LVDS connector catches (optional) -1-
Upon re-connecting the LVDS cable, ensure the catches are
locked after having inserted the LVDS cable.
Figure 4-10 SSB LVDS connector catches (optional) -2-
4.4
Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
•
While re-assembling, make sure that all cables are placed
and connected in their original position.
•
Pay special attention not to damage the EMC foams in the
set. Ensure that EMC foams are mounted correctly.
19370_080_130208.eps
130208
2
2
3
1
3
1
19370_081_130208.eps
130208
3
3
19054_001_111010.eps
111010
19222_001_120626.eps
120626
Click!
LVDS flat foil
Click!
