Philips QC5070, Manual

Page: 8 / 112

Optimising the lifetime of the battery
After the appliance has been charged for the first time, do not recharge it
between clipping sessions. Continue using it and recharge it only when
the battery is (almost) empty.
- Discharge the battery completely twice a year by letting the motor
run until it stops.
- Do not keep the appliance plugged into a wall socket all the time.
- If the appliance has not been used for a long time, it must be
recharged for 8 hours (NiCd battery) or 12 hours (NiMh battery).
Corded clipping
Do not run the appliance from the mains when the battery is fully
charged.
,
To use the hair clipper connected to the mains: switch the hair
clipper off, connect it to the mains and wait a few seconds before
switching it on.
using the appliance
Clipping with comb attachment
,
The hair length after cutting is indicated in millimetres on the result
indicator (Fig. 5).
,
The hair length after cutting is only visible when one of the combs
is attached. Use the small comb for a length of 3-21 mm and use
the large comb for a length of 23-41 mm.
1 Slide the comb attachment into the guiding grooves of the
appliance (‘click’) (Fig. 6).
Make sure that the arms of the comb attachment have been properly slid
into the grooves on both sides.
2 Set the comb to the desired hair length by turning the length
lock (Fig. 7).
The small comb cuts hair to a length of 3mm, 6mm, 9mm, 12mm, 15mm,
18mm or 21mm.
English
8