Mechanical Instructions
4.
4.4.6
Keyboard Control Board
The keyboard control panel is mounted on the LCD panel with
two screws.
When defective, replace the whole unit.
4.4.7
Ambilight Units
Refer to
for details.
Note:
the Ambilight units are to be swapped on PWB level.
Figure 4-9 Ambilight units
1.
Unplug the flat foil(s) [1].
2.
Release the clips [2] that secure the PWB.
3.
Slide the PWB out of the set [3].
4.4.8
LCD Panel
Refer to
for details.
1.
Remove the stand.
2.
Remove all boards as described earlier.
3.
Remove all cables from the set.
4.
Remove the speaker boxes as earlier described.
5.
Remove the IR & LED board cover as described earlier.
6.
Remove the mains switch [1].
7.
Remove the keyboard control panel as described earlier.
8.
Remove the clamps [2].
Pay attention to the positioning
of the different screws!
9.
Remove the plastic clamps [3].
10. Tilt the clamps [4] after having removed the screw.
11. Remove the Ambilight PWBs as earlier described.
12. Tilt the Ambilight subframes [5] after having removed the
screw.
Now the LCD Panel can be lifted from the front cabinet.
Figure 4-10 LCD Panel
Pay special attention to use the correct screws at the
proper location when mounting a new LCD panel!
Using the wrong screws will damage the LCD panel!
4.5
Assy/Panel Removal da Vinci Styling
(6000 series)
Instructions below apply to the LC9.3L LA chassis
(32PFL6605D/xx), but are similar for other models.
1
8
771_111_100504.ep
s
100504
3
3
2
1
1
8
771_112_100504.ep
s
100504
4
3
3
3
3
4
4
4
2
2
5
2
5
2
1
