Philips Norelco NT9145, Manual

Page: 6 / 69

Trimming with precision trimming head and precision
trimming comb
1 Put the precision trimming head on the appliance (see section
‘Attaching and detaching the attachments’ in chapter ‘Preparing for
use’).
Choose the short, medium or long precision trimming comb,
depending on the desired hair length. The indications ‘S’, ‘M’ and ‘L’
are on the combs.
Short precision trimming comb (S): 4mm
Medium precision trimming comb (M): 5mm
Long precision trimming comb (L): 6mm
Tip: We advise you to start trimming with the long comb.
Put the precision trimming comb on the precision trimming head and
push it until it locks into place (‘click’).
Switch on the appliance. Turn the battery compartment cover from
the ‘off’ position (0) to the ‘on’ position (I).
5 Move the appliance slowly and with light pressure against the
direction of hair growth.
Note: To make trimming easier, stretch the skin with your free hand during
trimming.
Note: Make sure that the flat part of the comb always touches the skin to
obtain an even result.
Note: Do not press the appliance with the comb onto the skin too hard. This
may cause the appliance to trim the hairs shorter than the length indicated on
the comb.
Note: In areas where the hair grows in different directions, move the appliance
upwards, downwards and sideways.
6 Regularly remove cut hairs from the comb. If a lot of hairs have
accumulated in the comb, detach the comb from the appliance and
blow and/or shake the hairs out of it.
-
-
-
ENglish
10
7 To switch off the appliance, turn the battery compartment to the ‘off’
indication (0).
8 To detach the comb, put your finger under the bottom edge of the
comb and pull it off the appliance.
shaving with precision shaving head
1 Put the precision shaving head on the appliance (see section
‘Attaching and detaching the attachments’ in chapter ‘Preparing for
use’).
Place the precision shaving head at a 5° angle onto the skin and
move the appliance slowly and smoothly against the direction of hair
growth.
Make sure that the whole shaving head is in contact with the skin.
As hairs grow in different directions move the appliance in different
directions against the hair growth.
To switch off the appliance, turn the battery compartment to the ‘off’
indication (0).
Cleaning
Clean the appliance immediately after use and when a lot of hair or dirt
has accumulated on the cutting elements.
Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the appliance.
Do not tap on the cutting elements.
Do not use any sharp objects to clean the cutting elements.
1 Switch off the appliance.
ENglish
11