ENGLISH
◗
Remove the protective razor head cap from
the razor before charging or cleaning the
razor in the Jet Clean System.
◗
Use this appliance for its intended household
use as described in this manual.
1
Place the Jet Clean System on a flat, level
surface.
C
2
Simultaneously press the buttons located
on both sides of the Jet Clean System
(
1
) and lift the appliance off the Jet Clean
canister (2).
Always remove appliance from canister by lifting
straight up. Do not tilt Jet Clean System.
3
Unscrew the lid on the Jet Clean Solution
bottle (Model HQ200) provided with the
razor. Remove the airtight seal by lifting up
the tabs on the seal.
C
4
Pour the Jet Clean Solution into the canister
up to the MAX indication located inside the
canister.
Make sure the canister is always filled above the
MIN indication located inside the canister.
NOTE: ONLY USE PHILIPS NORELCO JET
CLEAN SOLUTION (MODEL HQ200) WITH
THE JET CLEAN SYSTEM. ANY OTHER
SOLUTION MAY CAUSE DAMAGE TO YOUR
RAZOR.
22
ENGLISH
C
◗
When the cleaning solution level drops below
the minimum level, the cleaning and ‘cleaning
solution low’ lights will blink and the razor
holder will move to the starting position.
◗
If you clean your razor every day, you should
refill the canister approximately every 15 days.
C
5
Carefully lower the appliance back onto
the Jet Clean canister making sure the
release buttons snap back into place.
When the canister is filled with cleaning solution,
do not move appliance to prevent leakage.
Jet Cleaning the Razor
◗
If the razor does not contain enough power
for one (
1
) shave, the Jet Clean Cleaning
System may not work properly. Charge the
razor in the Jet Clean System before using the
it to clean your razor.
1
Connect the small plug to the Jet Clean
System. Connect the charging plug into
any 100V to 240V AC outlet. Use only the
charging plug provided.
2
. Place the Jet Clean System on a flat, level
surface. Fill the canister with cleaning
solution (see ‘Preparing Jet Clean System
For Use’).
23
