2
INSTALLATION
2.1
Installation summary
•
Connect Ethernet and power to the NetCam2 on a local network for
configuration (see 2.1.3).
•
Install the setup program for NetCam2 (see 2.2).
•
Assign an IP address to NetCam2 and configure its network settings (see
2.3).
•
Configure the operational settings (see 2.4).
•
Install NetCam2 in its location, and re-connect the power and Ethernet.
•
Adjust the focus (see section 6).
2.1.1
System requirements
•
Operating system: Windows 98, ME, NT4 or 2000
•
CPU: Pentium II or above
•
Minimum RAM: 128MB (Windows 98 and ME), 192MB (windows NT4
and 2000)
•
Ensure that either Internet Explorer 5.0 (or above) or Netscape Navigator
4.7 (or above) web browsers are available
2.1.2
Recommended PC display settings
Using the Windows ‘Setting / Control Panel / Display’ options, set:
•
Color option to ‘High color’ (16-bit) or above.
•
Screen resolution to 1024x768 pixels.
2.1.3
Connecting Ethernet and power cables
•
Connect an Ethernet LAN cable to the ‘Ethernet’ port (RJ-45 connector) on
the rear panel.
•
Connect the power supply (12V, 1.5 A adaptor, supplied) to the connector
marked ‘DC 12 V’ or use an alternative power supply unit on the AC 24 V
or the DC 12 V connector.
•
Confirm that the green LED on the Ethernet port flashes every 1 to 2
seconds. Note it starts flashing 5 to 6 seconds after applying power.
11
NetCam2
Section 2
NetCam2 _ii_00592en.qxd 1/23/03 2:22 PM Page 11
