23
English
3139 115 21511
To change the tape side on tape deck 2
only
●
During playback, press
A•B
(
SIDE
).
●
In stop mode, press
SIDE
on the remote
control.
➜
BACK
(reverse side) or
FRONT
(front side) is
displayed, depending on the tape side selected.
To change the playback mode on tape
deck 2 only
●
Press
A. REV
repeatedly to select the different
playback modes.
å
: playback on one side of the tape only.
ç
: both sides are played once.
∫
: both sides are played repeatedly, up to
10 times each side unless you press
STOP
(
Ç
).
To reset tape counter number to zero
●
During playback, press
DIM
for more than
two
seconds
.
●
The tape counter will automatically set to zero
after detecting end of tape or changing tape play
direction.
Rewinding / Fast forwarding
In stop mode
1
Press
S
or
T
(
à
or
á
).
➜
The tape will stop automatically at the end of
rewinding or fast forwarding.
2
Press
STOP
(
Ç
) to stop rewinding or fast
forwarding.
During playback
●
Press and hold
S
or
T
(
à
or
á
) until
the desired passage is reached, then release.
➜
The tape continues playing.
➜
During searching, the sound is reduced to a
low volume.
Note:
– During rewinding or fast forwarding of a tape, it
is also possible to select another source (3CDC or
TUNER, for example).
General information on
recording
●
For recording, use only tape of IEC type I
(normal tape).
●
The recording level is set automatically,
regardless of the position of the Volume, Bass/
Treble, Incredible Surround and so forth.
●
The tape is secured at both ends with leader
tape. At the beginning and end
of the tape, nothing will be
recorded for six to seven
seconds.
●
To prevent accidental recording,
break out the tab on the left
shoulder of the tape side you
want to protect.
●
If “
CHECK TAPE
” is displayed, the protection
tab has been broken. Put a piece of clear
adhesive tape over the opening.
IMPORTANT!
– Recording is permissible if copyright or
other rights of third parties are not
infringed upon.
– Recording is possible only on tape deck 2.
Preparation for recording
1
Press
TAPE
to select TAPE 2.
2
Load a recordable tape into tape deck 2.
3
Press
SIDE
on the remote control to select the
recording side.
4
Press
A. REV
repeatedly to select a recording
mode.
➜
å
for recording on one side only.
➜
ç
for recording on both sides.
Tape Operation/Recording
pg 001-030_MZ9_22-Eng
1/23/02, 1:59 PM
23
