Philips MRD210/37, Service Manual

Page: 11 / 45

3-1
DISASSEMBLY INSTRUCTIONS
1) Open the DVD Tray by using the Open/Close Button
while the Set is ON and disconnect the mains supply after
removing the Tray Cover.
Note: If this is not possible, the DVD Tray has to be open
manually.
Take a mini screw driver about 2mm diameter and make
a marking 24mm from the tip as shown in figure 2. Place
the set on its side, insert the mini screw driver till the
marking and slide it towards the right as shown in figure
1 until the Tray moves out of the Front Panel.
3) Loosen 11 screws and remove the Top Cover by lifting the
rear portion upwards before sliding it out towards the rear.
- 7 screws on the back
- 2 screws each on the left & right side
Dismantling of the Key Board Assembly
2) Return the set to its upright position and remove the Tray
Cover as shown in Figure 3 and close the tray manually
by pushing it back in.
Figure 1
Figure 2
3-1
Dismantling of the DVD Module Board
1) Loosen 4 screws A to remove the DVD module as shown
in figure 4.
Dismantling of the POWER Board
1) Loosen 2 screws "B " on the bottom cover as shown in
figure 5.
2) Loosen 4 screws "C " at the top of the Power Board as
shown in figure 6.
Figure 4
Figure5
Figure 3
24mm
2mm
Repeat
Marking just outside the
slot on the rear cabinet
Figure6
A
B
C