12
4
Insert fully the silver end of a speaker cable
into the left black (-) connector.
5
Screw the left black (-) connector to
secure the cable.
6
Repeat steps 2-5 to insert the other
speaker cable into the right connectors.
For the speakers:
1
Unscrew the speaker connectors.
2
For the left speaker, identify the speaker
cable that is connected to the left
connectors on the main unit.
3
Insert fully the red end of the speaker
cable into the red (+) connector.
4
Screw the red (+) connector to secure the
cable.
5
Insert fully the silver end of the speaker
cable into the black (-) connector.
6
Screw the black (-) connector to secure
the cable.
7
Repeat steps 2-6 for the right speaker.
Connect FM antenna
Tip
For optimal reception, fully extend and adjust the
position of the antenna.
For better FM stereo reception, connect an outdoor
FM antenna to the
FM ANTENNA
jack.
The audio system does not support MW radio
reception.
•
•
•
1
Connect the supplied FM antenna to the
FM ANTENNA
jack on the main unit.
3 Get started
Caution
Use the controls only as stated in this user manual.
•
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of your audio system.
The model number and serial number are on
the <TypePlateLocation> of your audio system.
Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Connect speakers
Note
Insert the stripped portion of each speaker wire into
the socket completely.
For optimal sound, use the supplied speakers only.
Connect only speakers with impedance that is the same
or higher than the supplied speakers (see ‘Speci
fi
cations’
on page 22 ) .
•
•
•
For the main unit:
1
Unscrew the speaker connectors.
2
Insert fully the red end of a speaker cable
into the left red (+) connector.
3
Screw the left red (+) connector to secure
the cable.
EN
Book_1.indd Sec1:12
Book_1.indd Sec1:12
2008-07-29 17:28:05
2008-07-29 17:28:05