English
7
General Information
Congratulations on your purchase and welcome
to Philips!
To fully benefit from the support that Philips
offers, register your product at www.philips.com/
welcome.
IMPORTANT!
PLEASE NOTE THAT THE VOLTAGE SELECTOR
LOCATED AT THE REAR OF THIS SYSTEM IS
PRESET AT 110V FROM THE FACTORY. FOR
COUNTRIES THAT OPERATE AT 220V-240V,
PLEASE ADJUST TO 220V-240V BEFORE YOU
SWITCH ON THE SYSTEM.
Supplied accessories
– 2 speaker boxes
– remote control
Environmental Information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags,
protective foam sheet).
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
Safety Information
●
Before operating the system, check that the
operating voltage indicated on the typeplate
(or the voltage indication beside the voltage
selector) of your system is identical with the
voltage of your local power supply. If not, please
consult your dealer.
●
Place the system on a flat, hard and stable
surface.
●
Where the MAINS plug or an appliance coupler
is used as the disconnet device, the disconnet
device shall remain readily operable.
●
The apparatus shall not be exposed to
dripping or splashing.
●
Install the unit near the AC outlet and where the
AC power plug can be easily reached.
●
Place the system in a location with adequate
ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 inches)
clearance from the rear and the top of the unit
and 5 cm (2 inches) from each side.
●
The ventilation should not be impeded by
covering the ventilation openings with items,
such as newspapers, table-cloths, curtains, etc.
●
Do not expose the system, batteries or discs to
excessive moisture, rain, sand or heat sources
caused by heating equipment or direct sunlight.
●
No naked flame sources, such as lighted candles,
should be placed on the apparatus.
●
No objects filled with liquids, such as vases, shall
be placed on the apparatus.
●
If the system is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lens of the disc
unit inside the system. Should this occur, the CD
player would not operate normally. Leave the
power on for about one hour with no disc in the
system until normal playback is possible.
●
The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
●
When the system is switched to Standby mode,
it is still consuming some power. To disconnect
the system from the power supply completely,
remove the AC power plug from the wall
socket.
MCM148_96_UM.indb 7
9/11/2009 10:47:39 AM
