4
Preparation
Surround loudspeakers
There are two surround loudspeakers supplied. One is the
active loudspeaker A.The other loudspeaker B is a passive
one which has to be connected with the active
loudspeaker.
•
The slide channel switch
1
at the bottom of the active
loudspeaker has been set default to channel 1 in the
factory. See also Sound Setup, p. 9.
•
Connect the active to the passive loudspeaker with the
supplied speaker cable
2
.
Insert the marked wire into the openings of the same
coloured connector clips on both speakers. Do not insert
the wires too far.
•
The Surround sound loudspeakers can be located behind
or to either side of the listener.The front of the
loudspeakers do not have to face the listener.
The distance between the TV and the surround speakers
should not exceed 15 m.
Note: In rare occasions people moving around close to the TV
may interfere with the sound transmission.
•
Set the position switch
3
to the right if the active
loudspeaker is positioned to the right side of the listener,
to the left if it is positioned to the left side of the listener
(seen from the point of view of watching the TV).
•
Connect the active loudspeaker to the mains with the
mains cable
4
.
•
Switch on the active loudspeaker with the
POWER
switch
5
.
The red indicator at the front of the active surround
speaker shows that the speaker is in standby.
During sound transmission the indicator turns to green.
10-15 min. after the sound transmission of the TV has
stopped, the indicator turns back to red to indicate the
low power standby.
To switch the active speaker off, use the
POWER
switch.
A
1
5
2
3
4
B
A
Should your remote control be lost or broken you can still
change some of the basic picture settings with the keys on
top of the TV.
Press the M key repeatedly to select
Volume, Brightness,
Colour, Contrast
,
Treble
and
Bass
.
Press the P - or + keys to carry out the selected adjustment.
When the menu adjustment is not displayed, the P- or +
keys enable you to select the TV channels, the
V
- or +
keys to adjust the volume.
The selected adjustment automatically switches off when no action
has been executed for 10 seconds.
Keys on top of the TV
V
P
M
2126.1 gb 04-12-2001 16:13 Pagina 4
