Philips LX 3700D, Service Manual

Page: 18 / 90

3-1
DISASSEMBLY INSTRUCTIONS
1) Open the DVD Tray by using the Open/Close Button
while the Set is ON and disconnect the mains supply after
removing the Tray Cover.
Note: If this is not possible, the DVD Tray has to be open
manually.
Take a mini screw driver about 2mm diameter and make
a marking 24mm from the tip as shown in figure 2. place
the set on its side, insert the mini screw driver till the
marking and slide it towards the right as shown in figure1
until the Tray moves out of the Front Pael.
Dismantling of the Front Panel Assembly
2) Return the set to its upright position and remove the Tray
Cover as shown in Figure 3 and close the tray manually
by pushing it back in.
3) Loosen 10 screws and remove the Top Cover by lifting the
rear portion upwards before sliding it out towards the rear.
- 10 screws on the bottom.
4) Loosen 3 screws & lift up the top edge of Front Panel
assembly to free some catches before sliding it out
towards the front.
- 3 screws on the inside.
- 1 screw "F" on the inside as indicated in Figure 5.
Figure 5
Figure 2
3-1
Figure 1
24mm
2mm
1) Loosen 4 screws "A" to remove the DVD module as
shown in figure 5.
Figure 4
Note: Do not lost the limited
parts of the Servo board
Figure 9
Dismantling of the Servo Board
Dismantling of the Main Board
Figure 3
Figure 10
A
H
B
Figure 6
Figure 7
Figure 8
Dismantling of the Key Board
1) Loosen 2 screws "C" at the top of the button as shown in
figure 6.
2) Loosen 6 screws"D" at the top of the key board 1 as shown
in figure 7.
3) Loosen 7 screws"E" on the button bottom of the key board
2 as shown in figure 8.
Repeat
Marking just outside the
slot on the rear cabinet Marking just outside the
slot on the rear cabinet
D
C
E
1) Loosen 6 screws "G" on the top of main board as shown in figure 9.
2) Loosen 4 screws "H" at the main bottom as shown in figure 10.
3) Loosen 8 screws "I" at the back panel as shown in figure 12.
(SCART : Loosen 8 screws)
(RGB
: Loosen 9 screws)
G
F