www.philips.com/knx
•
Specifications subject to change without notice.
© Not to be reproduced without permission.
Unit 6, 691 Gardeners Road Mascot 2020 Australia.
ABN 33 097 246 921
P1PE-KNX-2P / P1PE-KNX-4P /
P1PE-KNX-2P-2G / P1PE-KNX-4P-2G Installation Manual
Rev D May 2012
P PE-KNX-2P / P PE-KNX-4P / P PE-KNX-2P-2G / P PE-KNX-4P-2G
LightMaster Switch Range
INSTALLATION MANUAL
Basic Installation Steps
1. Select a dry location and install wallbox or mounting box
of appropriate type.
2. Prior to cable stripping and termination ensure power is
disconnected from KNX network.
3. Terminate KNX TP1 network cable. Ensure segregation
from mains.
4. If using a double Gang Switch, i.e. Part P1PE-KNX-4P-
2G or P1PE-KNX-2P-2G, connect the bus ribbon cable
between the two modules.
5. Insert switch into the wall box or mounting box and
secure with mounting screws. Do not over-tighten.
6. Snap faceplate into place.
Product Specifications
Control IO
KNXTP1 Bus, 21-30Vdc, Max 10mA
Bus Load
KNX Terminals
Wago 243
(Red/Grey) 0.6-0.8mm wire diameter
Single Core KNX Cable
Front Cover Finishes
Arctic White
Button Colours
Arctic White
Environment
-5º to 45ºC operating ambient
temperature
-25º to 55ºC storage temperature
0% to 90% RH non condensing
Compliance
CE, KNX
Materials
Plastic housing
Protection Class
IP20
Dimensions
Single Gang Bezel H 83mm x W 83mm
Two Gang Bezel H 150mm x W 83mm
Max Group Addresses
80
60
Back View
EIB/KNX
+
–
