Features
• This device is designed for use on KNX TP1 communication bus as a:
• Rocker switch
• Or single key pushbutton.
• The switch is available in 2 or 4 positions in either single or double
gang variants.
Important Notes
Read Instructions
–
We recommended that you read this Installation
Manual prior to commencement of installation.
Special Programming
–
To enable full functionality the device is required
to program using ETS software.
Installation Location – Install in a dry location, close to the equipment
to be interfaced with.
Panel interconnect ribbon cables – Maximum recommended length is
0.5 metre. They shall be double insulated and segregated from mains
and load cables in accordance to the local wiring code.
WARNING
•
•
•
• This device must only be installed and configured
by a qualified professional.
• Connect to KNX TP1 bus only following KNX
installation rules and local wiring code.
• KNX TP1 bus must be isolated and segregated from
mains and other wiring as per the local wiring rules
and KNX installation recommendations.
• Do not expose this device to rain or moisture.
Install in a dry location, indoors only.
• Do not open the device! For service inquiries
contact Philips Lighting.
P PE-KNX-2P / P PE-KNX-4P /
P PE-KNX-2P-2G / P PE-KNX-4P-2G
LightMaster Switch Range
INSTALLATION MANUAL
ISOLATE FROM MAINS SUPPLY PRIOR
TO INSTALLATION OR SERVICING. NO USER
SERVICEABLE PARTS INSIDE. INSTALLATION
AND SERVICE BY QUALIFIED PERSONNEL
ONLY
