Philips LFH 9750/00, Service Manual

Page: 6 / 16

6
MAC Address
After replacement of the DSP-Print (PCB2) the original MAC address of the unit, which
is equal with the Serial number of the machine, has to be set.
Download the MAC Address programming tool <
SerialNumber.exe >, the
< FACTORY.bin > file and the < DPMFIRMWAREUPGRADE.EXE > file from
http://www.speech.philips.com/service/ to a dedicated directory on your PC.
To set the MAC Address (after replacement of PCB2):
It is strongly advised to follow the correct sequence given below !
1. Push the Trigger Firmware Upgrade switch on the rear of the machine (through the
hole marked with P) by using a small pin whilst simultaneously plugging in the power
supply. To confirm the Upgrade mode the Display is now switched off.
2. Start the <
SerialNumber.exe > file.
3. Connect the LFH 9750 to the PC by using the USB download cable.
Set the PCB to EU (International) or US version (12 hours PM/AM or 24 hours clock).
Type in the Serial number of the machine mentioned on the type level on the bottom plate.
Click “OK”
Click “OK”
4. Disconnect the USB cable.