Mechanical Instructions
4.
4.3
Assy/Panel Removal
4.3.1
Rear Cover
Warning:
Disconnect the mains power cord before you remove
the rear cover.
1.
Place the TV set upside down on a table top, using the
foam bars (see part “Service Position”).
2.
Remove rear cover screws and the stand (if mounted).
3.
Remove rear cover.
4.3.2
Keyboard Control Panel
1.
Remove the rear cover, as described earlier.
2.
Refer to fig. “Keyboard control panel” below.
3.
Remove the T10 parker screws [1].
4.
Unplug connector [2].
5.
Remove the unit.
6.
Release clips [3] and remove the board.
When defective, replace the whole unit.
Figure 4-8 Keyboard control panel
4.3.3
Side I/O Panel
1.
Remove the rear cover, as described earlier.
2.
Unplug connector [a].
3.
Remove screws [b] and remove the complete module. One
of the screws is T10 tapping, the other one is T10 parker.
See fig. “Side I/O module”.
4.
Remove T10 parker screw [c]. See fig. “Side I/O panel 1”.
5.
Push catch [d] (located at the underside of the bracket) and
slide the unit to the right from its bracket [e]. See fig. “Side
I/O panel 2”.
6.
To remove the PWB from its bracket, you have to lift the
catch [f] located on top of the headphone connector. At the
same time, slide the PWB out of its bracket [g]. See fig.
“Side I/O panel 3”.
When defective, replace the whole unit.
Figure 4-9 Side I/O module
Figure 4-10 Side I/O panel [1/3] top side
Figure 4-11 Side I/O panel [2/3] bottom side
G_16
8
50_007.ep
s
3
10707
2
1
1
3
G_16860_066.eps
010207
a
b (1x)
b (1x)
G_16860_075.eps
010207
c
G_16860_076.eps
010207
2
d
2
e
