Mechanical Instructions
4.
4.
Mechanical Instructions
Index of this chapter:
Note:
Figures can deviate slightly from the actual situation, due
to different set executions.
4.1
Rear Cover Removal
1.
Remove all fixation screws of the rear cover.
2.
Now pull the rear cover backward and remove it.
4.2
Service Position Main Panel
1.
Disconnect the strain relief of the AC power cord.
2.
Remove the main panel, by pushing the two center clips
outward [1]. At the same time pull the panel away from the
CRT [2].
3.
Disconnect the degaussing coil by removing the cable from
(red) connector 0201.
4.
Move the panel somewhat to the left and flip it 90 degrees
[3], with the components towards the CRT.
Figure 4-1
4.3
Side I/O Panel Removal
1.
Remove the complete Side I/O assembly after unscrewing
the 2 fixation screws [1].
2.
Release the two fixation clamps [2] and lift the board out of
the bracket.
Figure 4-2
4.4
Rear Cover Mounting
Before you mount the rear cover, perform the following checks:
1.
Check whether the mains cord is mounted correctly in its
guiding brackets.
2.
Replace the strain relief of the AC power cord into the
cabinet.
3.
Check whether all cables are replaced in their original
position.
A
B
1
CL 16532016_006.eps
220501
2
1
3
CL 06532012_004.eps
030200
