32
1
To separate the charger cover from the charger base, press the
two grey snap bars on the charger base and pull the white charger
cover upwards.
2
Wrap excess power cord around the grey charger base as shown
in the picture. Be sure to wrap the cord on the inside of the two
snap levers.
3
When you have stored the excess cord, guide the mains cord
through the small groove in the rear of the grey charger base.
4
To reattach the charger cover, press it down over the charger base
until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel
charger and use it without the charger cover and charger base.
Integrated cord wrap of UV sanitizer
You can store excess cord using the cord wrap feature built into the
bottom of the sanitizer.
Sanitizing
- With the UV sanitizer you can clean your brush head after every
use (Fig. 8).
Unplug the sanitizer, discontinue use and call Consumer Care if:
- The UV light bulb remains on when the door is open.
- The window is broken or missing from the sanitizer.
- The sanitizer gives off smoke or a burning smell while it is
operating.
Note: UV light can be harmful to the human eye and skin. This device
should be kept out of reach of children at all times.
1
After brushing, rinse the brush head and shake off excess water.
Warning: Do not place the travel cap on the brush head
during sanitization.
2
Place your finger in the door recess on top of the sanitizer and pull
open the door (Fig. 9).
3
Place the brush head on one of the 2 pegs in the sanitizer with the
bristles facing the light bulb (Fig. 10).
English
Summary of Contents for HX6962/76
