Philips HTS3264-Mk2, Service Manual

Page: 11 / 30

3 - 1 3 - 1
DISASSEMBLY INSTRUCTIONS
3) Loosen 6 screws and remove the Top Cover by lifting the rear portion upwards before sliding it out towards the rear.
- 1 screw “A” each on the left & right side as shown in fi gure 4.
- 4 screws “B” at the back panel as shown in fi gure 5.
4) Loosen 6 screws “C“ at the bottom panel as in fi gure 6 to remove the front panel.
A
Figure 4
B
Figure 5
PUSH
24mm
m
m
2
Figure 1
Figure 3
Figure 2
Dismantling of the Front Panel Assemble
1) Open the DVD Tray by using the Open/Close Button while the Set is ON and disconnect the mains supply after removing the Tray
Cover.
Note: If this is not possible, the DVD Tray has to be open manually.
Take a mini screw driver about 2mm diameter and make a marking 24mm from the tip as shown in fi gure 2 . Place the set on its
side, insert the mini screw driver till the marking and slide it towards the left as shown in fi gure 1 until the Tray moves out of the Front
Panel.
2) Return the set to its upright position and remove the Tray Cover as shown in Figure 3 and close the tray manually by pushing it back
in.
Figure 6
C