24
Philips · Screeneo U3
DANGER!
Instructions for cleaning!
To reduce the risk of electrical shock,
always turn the projector off and
disconnect the power cable before
changing the lamp.
To reduce the risk of severe burns,
allow the projector to cool for at least
45 minutes before replacing the lamp.
To reduce the risk of injuries to fingers
and damage to internal components,
use caution when removing lamp glass
that has shattered into sharp pieces.
To reduce the risk of injuries to fingers
and/or compromising image quality
by touching the lens, do not touch the
empty lamp compartment when the
lamp is removed.
This lamp contains mercury. Consult your
local hazardous waste regulations to
dispose of this lamp in a proper manner.
1
Turn off the projector and disconnect the
power cable from the power supply.
Notice
The lamp becomes extremely hot during
operation. Allow the projector to cool
for approximately 45 minutes prior to
removing the lamp.
2 Find the connector cover on the bottom of
the left side panel of the projector. Open
the connector cover to find two small
screws which fasten the lamp cover. Then
use an appropriate screwdriver to remove
the two screws, and remove the lamp cover.
CAUTION!
Do not connect the projector to
power supply while the lamp cover is
removed.
Do not insert your fingers inside the
projector. The sharp edges may cause
injuries.
3 Loosen the two screws which fasten the
lamp. See the figure below.
4 Gently pull the lamp out by holding the two
tabs. See the figure below.
CAUTION!
Pulling the lamp too fast may cause
the lamp to break and scatter broken
glass inside the projector.
Do not place the lamp in locations
where water might splash on
it, children can reach it, or near
flammable materials.
Do not insert your hands inside the
projector after the lamp is removed.
If you touch the optical components
inside, it could cause colour
unevenness and distortion of the
projected images.
5 Gently insert the new lamp. If it doesn’t fit
easily, make sure it is inserted in the correct
way.
6 Tighten the two screws which secure the lamp.
