Philips HD7466, Directions For Use Manual

Page: 8 / 92

The light goes on.
Let the appliance run until the water tank is completely empty.
4 Switch the appliance off when all the water is in the jug.
5 Let the appliance cool down for at least 3 minutes before you start
brewing coffee.
using the appliance
1 Open the lid (Fig. 3).
2 Fill the water tank with fresh, cold water (Fig. 4).
The water level indicator shows the amount of water in the water tank.
The graduations correspond to large cups (125 ml). Make sure that the
water level does not exceed the MAX indication.
3 Close the lid.
4 Place the jug on the hotplate.
5 Open the filter holder (Fig. 6).
6 Take a paper filter (type 1x2 or no. 2) and fold the sealed edges to
prevent tearing and folding.
In some countries this coffeemaker comes with a permanent filter. In that
case you should not use paper filters.
7 Put the filter in the filter holder.
8 Put pre-ground coffee (filter-fine grind) in the filter (Fig. 7).
For large cups: use one heaped measuring spoon of ground coffee for
each cup.
For small cups: use one level measuring spoon of ground coffee for each
cup.
9 Close the filter holder.
10 Switch the appliance on by pressing the on/off switch (Fig. 5).
Note: The light goes on.
EnglisH
8