English
5
Transmitter (figure 1)
1 IR transmitting LEDs
– transmit audio
signal to IR headphone.
2 DC power
– connect to the 12 Volt/
200 mA AC/DC adapter.
3 Power switch
– power on/off switch.
4 3.5 mm stereo headphone audio
input
– connects your IR transmitter to an
audio source.
5 Controls plate
Headphone (figure 2)
6 IR sensors
– to receive IR waves from the
transmitter
7 Power indication
– lights up when in use.
8 Power On/Off
– slide the switch to the
on or off position to switch the headphone
on/off.
9 Volume
– adjust volume to your desired
listening level.
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00
12 Volt/200 mA AC/DC adapter.
(For UK, use only Philips SBC CS030/05)
1
Make sure the adapter’s rated voltage
corresponds to the mains socket voltage.
2
Connect the DC connector of the AC/DC
adapter to the 12 Volt DC power input
connector located at the rear of the
transmitter.
3
Connect the 12 Volt/200 mA AC/DC
adapter to the mains socket.
– Always disconnect the AC/DC adapter if
the transmitter is not to be used for a
long period of time.
Headphone power supply
1
Check if the power button of the
IR headphone is in the on position.
2
Ensure the batteries are put in the battery
compartment correctly according to the
engraved polarity symbols.
Note:
Always remove the batteries if the
headphone is not to be used for a long period
of time.
Batteries contain chemical substances,
so they should be disposed of properly.
Controls
Installation
Environmental Information
All redundant packing material has been omitted.We have done our best to make the
packaging easily separable into two materials: cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
XP SBC HC 065/00-1 29-08-2001 11:16 Pagina 5
