Philips HB950, User Manual

Page: 7 / 48

If your skin feels slightly taut after tanning, you can apply a moisturising cream.
B
Note: If you are only tanning a part of your body, you can also use the tanning schedules
mentioned in the table above, together with the information in the chapter 'Tanning sessions:
how often and how long?'
Relax sessions: how often and how long?
HB955 only
If you do not want to get up right away after the tanning session, you can switch on the infrared
lamps for a relax session, during which the infrared lamps keep you warm.
You can also take a relax session without a tanning session.You can do this several times a day (e.g.
30 minutes in the morning and in the evening).
Preparing for use
◗
The appliance can be easily moved and stored in transport position (fig. 2).
◗
If you want to give your face an extra tan (types HB951 and HB952 only) or if you only want
to tan a part of your body (i.e. just the legs or the upper half of your body; types HB952 and
HB955 only), make sure you place the appliance at the correct side of the bed (fig. 3).
1 Open the appliance by pulling the catches on both sides of the base out as indicated by the
arrow (fig. 4).
The upper part of the appliance is now unlocked.
2 The upper part comes slightly up (by itself or with a little help) (fig. 5).
3 Grab the handle with both hands and put one foot against the appliance to prevent it from
sliding away.Tilt the upper part by pulling the handle and tracing an arc with it (fig. 6).
Do not tilt the upper part too far.
4 Pull the upper part up and towards you at the same time (fig. 7).
This requires some effort.
5 Move both lamp units sideways as far as possible, until they are in line with each other (fig. 8).
6 The distance between the UV filters and your body must be 65 cm.The distance between
the UV filters and the surface on which you are lying down (e.g. a bed) must be 85 cm (fig. 9).
7 Support the upper part of the stand when you set or adjust the height of the appliance
(fig. 10).
Loosen knob 'A' by turning it anti-clockwise (two or three turns).
8 Put your hand under the horizontal part of the stand and extend the stand to the required
height (fig. 11).
9 Firmly fasten knob 'A' again and release the stand (fig. 12).
◗
You can determine whether the appliance has been set to the required height by pulling out
the measuring tape (fig. 13).
◗
The measuring tape will automatically rewind if you move the red tab sideways (fig. 14).
The appliance is now ready for use.
ENGLISH
7