10
September 2018
Application Guide - Philips GreenPower LED production module
Input voltage
Peak current
Half peak
width
Maximum pieces per breaker
16 A C-type
15 A C-type
120 V
3 A
0.8 ms
48
45
230 V
5.5 A
0.8 ms
43
40
277 V
7 A
0.8 ms
34
32
A
C
D
B
Total length
Mains power cable
Branch cable
Inrush current with calculation example
Cable tree design guidelines
Cable trees can be customized to create the most optimal
solution for each project. It can be ordered with a minimum
of 2 and a maximum of 10 branches. Lengths A, B, C and D
are determined based on the installation layout, with the
following design restrictions:
• Total length < 10 m = A + n x B + D (n = number of branches - 1)
• Length A,B,C and D > 0.25 m
For more information (minimum order quantity, ect)
see ordering data.
Please contact your sales representative in case you want to
know more about this solution.
Cable trees can be daisy-chained. Maximum load on all
interconnected cable trees may not exceed 20 Amps.
The inrush current for the GreenPower LED production
modules is according to the table, also with
a calculation example of the maximum amount of
GreenPower LED production module on a single circuit
breaker.
Turn off and disconnect the power before installation.
Installation must be performed by a qualified electrician in accordance with all national and local electrical and
construction codes and regulations.
• Make sure that power cords are routed in a manner that will prevent incidental damage
• Use wet-rated (IP66) junction boxes which are also suitable for the power cords used in the application.
• Use a strain-relief or power cord grip if needed.
• Use a cable gland suitable for use with three conductor and type off cord suitable for the trade size of the junction
box provided by others, if needed.
•
DO NOT connect to live power until installation is complete.
•
DO NOT attempt to install or use until you have read and understood the installation instructions of this product
contained in the Quick Installation Guide, this Application Guide and safety labels.
•
DO NOT modify or alter the product; doing so will void the warranty.
Important
