In-car connections
(supplied or optionally available)
Use only the AY 3545 or AY 3548 car voltage converter (4.5 V DC, positive
pole to the centre pin) and the AY 3501 car adapter cassette. Any other
product may damage the set.
1
Put the set on a horizontal, vibration-free and
stable surface. Make sure it is in a safe place,
where the set is neither a danger nor an
obstacle to the driver and the passengers.
2
Plug the voltage converter into the cigarette
lighter socket
(only for a 12 V car battery,
negative grounding)
, then connect the
wired end with the 4.5V DC input socket on
the set.
3
If necessary, clean the cigarette lighter socket to obtain a good electrical
contact.
4
Turn down the volume and connect the adapter cassette plug to
LINE OUT/
p
on the set.
5
Carefully insert the adapter cassette into the car radio’s cassette
compartment.
6
Make sure the cord does not hinder your driving.
7
Set VOL
E
on the set to position 8. Start playback on the set and adjust
the sound with the car radio controls.
Always remove the voltage converter from the cigarette lighter socket
when the set is not in use.
Note: If your car radio has a
LINE IN
socket, it is better to connect the set to
this socket instead of using the adapter cassette. Connect
LINE OUT/
p
of the
set with the
LINE IN
socket of your car radio with an appropriate cable.
25
Accessories
English
ESP and powersaving
With a conventional portable disc player
the music may stop while you are jogging, for
example.The
E
lectronic
S
kip
P
rotection
protects this set against loss of sound caused
by light vibrations or shocks. Continuous
playback is ensured.
ESP does not protect
the set against damage caused by
dropping!
●
Press ESP repeatedly during playback to select
either:
–
ESP on
:
is shown and ESP is
switched on.
–
Longer battery playing time
:
is shown. ESP and powersaving are switched on, resulting in
a longer battery lifetime and a shorter skip protection.
–
ESP off
:
disappears. ESP and powersaving are switched off
for CD Audio tracks to achieve the highest sound quality.
Beep
A beep confirms that you have pressed a
button or that the batteries are empty.
●
Keep DBB/TREBLE pressed for 2 seconds to
switch beep either on or off:
➜
Beep
is displayed: Beep is switched on.
➜
No beep
is displayed: Beep is switched off.
24
Features
English
EXP511,513/00c.1 eng 1/3/02 15:11 Page 24
