Philips ESSENCE +, Instructions Manual

Page: 15 / 36

15
English
2
Remove and discard the brush head. Cover the
entire handle with a towel or cloth.
3 Hold the top of the handle with one hand and
strike the handle housing 0.5 inch above the
bottom end. Strike firmly with a hammer on all
4 sides to eject the end cap.
Note: You may have to hit on the end several
times to break the internal snap connections.
4 Remove the end cap from the toothbrush
handle. If the end cap does not release easily
from the housing, repeat step 3 until the end
cap is released.
5
Holding the handle upside down, press the
shaft down on a hard surface. If the internal
components do not easily release from
the housing, repeat step 3 until the internal
components are released.
6
Remove the inner assembly from the housing
by fully inserting a small flat-head screwdriver
into the slot opposite the circuit board and pry
until it comes apart.
4235_021_0677_1_Booklet_A6_v2.indd 15 18/11/15 10:48