installation steps
connecting data cable
product specifications
1. Decide if the equipment to be connected to the RS232 port
is classified as COMPUTER (DTE) or MODEM (DCE). The
factory setting for the RS232 port is Computer. To change
this setting to MODEM remove the cover and move the
mode jumpers to the MODEM position.
2. Connect the RS232 port on the DNG232 to the RS232 port
on the other device using a 9 pin D connector straight
through cable.
3. Connect the RS485 cable to the DyNet 5 way terminal strip.
Note that this device consumes 40mA of power from the
DyNet network
4. The factory settings will allow control of a Dynalite system
via plain English text strings that can be sent by a terminal
program such as the one included in Microsoft Windows,
which allows the DNG232 to be easily tested. See the
section on Plain English commands. Detailed programming
information is available in the document: DNG232
Programming Manual
RS485 Serial Port:
1 x RS485 unterminated DyNet, consisting of 1 x RJ12 socket & 1 x 5 way terminal strip, for permanent
connections
RS232 Serial Port:
1 x RS232 9 pin female D connector
RS232 Port Modes:
COMPUTER (DTE), MODEM (DCE)
RS232 Data Formats:
Baud rate: 1200 - 460800, Max packet length: 254 bytes, Data bits: 7/8, Stop bits: 1/2, Parity:
odd/even/none
User Controls:
Service Switch, Diagnostic LED
Internal Controls:
Programmable Logic Controller
Operating Environment:
0º to 50ºC ambient temperature, 0% to 95% RH non condensing
Power Consumption:
40mA from the DyNet network
Compliance:
CE, C-Tick
Ambient Temperature:
50
C max.
Construction:
ABS plastic stand alone enclosure
Dimensions:
H 30mm x W 80mm x D 150mm
Weight:
0.15Kg
DMNG232 Instruction Manual Rev E.Doc Specifications subject to change without notice
Dynalite manufactured by WMGD Pty Ltd (ABN 33 097 246 921) Unit 6, 691 Gardeners Road Mascot NSW 2020 Australia Tel: +61 2 8338 9899 Fax: +61 2 8338 9333
E-Mail:
Web:
dynalite-online.com
RS232 Connector:
9 pin Female D connector
RS232 Connector Pinouts
Pin
Function
Implementation
1
DCD (data carrier detect)
Not connected
2
RD (received data)
Connected to UART
3
TD (transmitted data)
Connected to UART
4
DTR (data terminal ready)
Not connected
5
SG (signal ground)
Connected to Ground
6
DSR (data set ready)
Not connected
7
RTS (request to send)
Software controlled
8
CTS (clear to send)
Software controlled
9
RI (ring indicator)
Not connected
connecting RS232 data cable
Connect Data Cable in a „Daisy Chain‟
RJ12 Socket Connections
Serial Cable Permanent Connections
recommended cable colour coding
Green/White Pair
paralleled for GND
Orange/White Pair
paralleled for +12V
Blue/White Pair
Blue for DATA+
White for DATA-
recommended cable types
Belden:
9503
Garland:
MCP3S
Hartland:
HCK603
M&M Cable:
B2003CS
Dynalite:
DYNET-STP-CABLE
M&M cable:
B9503CS
Multicables:
AWME120236209220
RS Components:
368-687
