Preparation to upgrade software
2) Start the CD Burning software and create a new CD
project (Data Disc) with the following setting:
Label:
DVP3XXX
(No need the label name)
on remote control to check the SW
File Name.
3) Burn the data onto a blank CDR
A. Procedure for software upgrade:
1) Power on the set and insert the prepared Upgrade CDR.
2) The set will starts reading disc & response with the
following display TV screen:
Upgrade file detected
Upgrade ?
4) The upgraded tray will automatically open when file
copying completed, then take out the disc.
5) About 1 minute later, the trace will automatically close
when upgrading completed.
B. Read out the software versions to confirm upgrading
remote control.
The software version and other informations will be
displayed on the TV screen as follows:
Version XX.XX.XX.XX (Main version)
Sub-Ver XX.XX.XX.XX (version of applicaton software)
8032 XX.XX.XX.XX
Servo XX.XX.XX.XX (software version of Servo)
DSP XX.XX.XX.XX
3-1
Caution: The set must not be power off during
upgrading, Otherwise the Main board will be
damaged entirely.
RISC XX.XX.XX.XX
A) Upgrade software via CDR:
1) Power on the set and open the tray, then press "5""5"
SW File Name:
Note: It is required to keep the SW file name accord.
Press PLAY to start
DVPXXXX_XX.bin
3) Press "PLAY" button to confirm, then screen will display:
Upgrade file detected
Do not power off
File Copying
Upgrade file detected
Do not power off
Upgrading
1) Power on the set and press "Setup" button on the
2) Press "1""3""7""9" button or press down cursor
on remote control to select "Preferences" and press
right & down cursor to select "Version Info".
Region Code X
Softeware upgrade and region code change
Region Code Change
1) Power on the set and open the tray door;
2) Press the "Setup" button on the remote control, then the
setup interface will be displayed on the TV screen;
3) Move the down cursor on remote control to select "Preferences"
and press "1""3""8""9""3""1" on the remote control;
4) Then move the up or down cursor to select the region code.
Note: Restart after above steps.
B) Upgrade software via USB Flash Drive
(only for USB 2.0)
:
1) Create the correct software file onto the USB flash drive.
2) Power on the set and keep no disc, then insert it to the
USB jack of the front panel.
3) When the DVD player switchs to the USB state automatically,
pls follow the instructions on the TV screen to confrim the
upgrade operation.
