Philips DVP3516, User Manual, Page: 11 / 18

12
• [Movie Mode] - Select a sound effect for
movies.
• [Music Mode] - Select a sound effect for
music.
[Speaker Setup]
Optimize the surround output for the connected
speakers.
[CD Upsampling]
For better sound quality in stereo mode, convert
the music CD to a higher sampling rate.
•
[Off] - Turn off CD-upsampling.
• [88.2kHz] - Convert to twice the original
sampling rate.
• [176.4kHz] - Convert to four times the original
sampling rate.
[Night Mode]
Make loud sound level softer and soft sound level
louder so that you can watch the DVD movies at a
low volume, without disturbing others.
•
[On] - Enjoy quiet viewing at night.
• [Off] - Enjoy surround sound with a full
dynamic range.
Note
Applicable only to Dolby Digital encoded DVDs.
•
Video setup
1
Press SETUP .
»
[General Setup] menu is displayed.
2
Press to select [Video Setup] , and then
press to enter the submenu.
3
Select an option, and then press OK .
4
Select a setting, and then press OK .
To return to the previous menu, press •
BACK .
To exit the menu, press • SETUP .
[TV System]
Change this setting if the video does not appear
correctly. By default, this setting matches the most
common setting for TVs in your country.
• [15 Mins] , [30 Mins] , [45 Mins] , [60 Mins] -
Select the countdown time for this product to
switch to standby.
[Auto Standby]
Turn on/off the auto standby mode.
•
[On] - Switch to standby after 15 minutes
of inactivity (for example, in pause or stop
mode).
• [Off] - Disable the auto standby mode.
Audio setup
1
Press SETUP .
»
[General Setup] menu is displayed.
2
Press to select [Audio Setup] , and then
press to enter the submenu.
3
Select an option, and then press OK .
4
Select a setting, and then press OK .
To return to the previous menu, press •
BACK .
To exit the menu, press • SETUP .
[Analogue Output]
Select an analogue setting based on the audio
device that is connected through the analogue
audio jack.
•
[LT/RT] - For the surround sound output
through two speakers.
• [Stereo] - For the stereo output.
• [Multi Channel] - For multi-channel output.
[Volume]
Set the default volume level when you play a disc.
1. Press OK .
2. Press to set the volume.
3. Press OK to confirm and exit.
[Sound Mode]
Select a preset sound effect to enhance the audio
output.
•
[3D] - Select a virtual surround sound effect
that is produced from the left and right audio
channels.
EN