Philips DVP3350K Series, Service Manual, Page: 14 / 46

Software upgrade
Preparation to upgrade software
1) Start the CD Burning software and create a new CD
project (Data Disc) with the following setting:
Label: DVP3XXXX (No need the label name)
File Name: DVPXXXXX_XX.BIN
Power on the set and open the tray, then press <5><5>
to check the File Name.
Note: It is required capital letter for the File System
name.
2) Burn the data onto a blank CDR
A. Procedure for software upgrade:
1) Power on the set and insert the prepared Upgrade
CDR.
2) The set will starts reading disc & response with the
following display TV screen:
Upgrade File DETECTED
Upgrade?
Press Play TO START.
3) Press <OK> button to confirm, then screen will display :
Files coping…
UPGRADING…
4) The upgraded tray will automatically open when files
coping complete, then take out the disc.
5) About 1 minute later, the trace will automatically close
when upgrading complete.
B. Read out the software versions to confirm upgrading
1) Power on the set and press <Setup> button on the
remote control.
The software version and other information are display
on the TV screen as follows:
4-1
Caution: The set must not be power off during
upgrading, Otherwise the Main board will be
damaged entirely.
Region Code Change
1) Power on the set and open the tray door;
2) Press the "Setup" button on the remote control,then
the setup interface should be displa
y
ed on the TV screen;
3) Move the down cursor on remote control to choose "Reference"
and press "1" "3" "8" "9" "3" "1"
on the remote control;
4) Then move the up or down cursors to choose the region code.
Note: restart after above steps.
* The other upgrade SW way is by memory, the steps are the
same as CDR's, create the upgrade file into memory, and
connect the USB flash drive to the USB socket on set, then
press "USB" on remote control to access the content and
play the upgrade file as above upgrade procedure.
*
2) Press<1><3><7><9> button or press down cursor
on remote control to choose "Preference" and press
right & down cursors to choose "Version Info".
Model DVP33XXX XX
File Name DVP33XXX XX.BIN
Version XX.XX.XX.XX
RISC XX.XX.XX.XX
Servo XX.XX.XX.XX
Region Code X
HDCP PASS(except press<1><3><7><9>)