Philips DVDR70/001, Service Manual

Page: 45 / 260

Mechanical Instructions EN 45 DVDR70 & DVDR75/0x1 4.
4. Mechanical Instructions
4.1 Dismantling and Assembly of the Set
For item numbers please see the exploded views in chapter 10.
4.1.1 Manually opening the tray
– In case the loader is defective or cannot be opened
electrically you can open the tray manually.
– Through a slot at the underside of the cabinet a slider that
unlocks the tray can be accessed.
However in sets with drive VAD8031 (AV3) the slot is
covered by an adhesive tape on the cabinet of the drive to
prevent dust coming into the drive. Push through this
adhesive tape by means of a thin screwdriver and move
the slider to the left, see picture 4-1.
– Make sure that an adhesive tape has been reapplied to
the AV3 drive when repair is finished!
Figure 4-1
4.1.2 Front
– After removing the top cover, remove tray front (1), see
picture 4-2
– Remove the three screws (2) that fix the front panel
– Release the two snap hooks on the sides (3)and remove
the front (4)
– Remove the 9 screws (5) to remove the front plate (6), see
picture 4-3
Figure 4-2
Figure 4-3
1
2
2
2
3
3
4
5
6