101
PROBLEM/HINTS
SOLUTION
The wrong TV channel
was decoded
(recorded) after you
programmed a
recording using VIDEO
Plus+
®
System.
b
The programme number of the TV channel is not available in the GUIDE Plus+
®
system or allocation is
wrong.
To change or check the channel data, proceed as follows:
1
Press
GUIDE/TV
J
.
2
Press
A
I
.
3
Select '
Editor
' with
C
M
.
4
Select the TV channel using
B
O
or
A
I
.
5
Press
C
M
to go to the right tile.
In case you can receive the selected channel only via an external receiver, press the red
button to select the corresponding source.
6
Press the green button.
7
Enter the programme number of the TV channel using the number buttons.
If the source you have selected is an external receiver, enter the programme number that you
would also enter at the external receiver for this TV channel.
8
Confirm with
OK
L
.
b
If no GUIDE Plus+
®
data is available, enter the right programme number after you have confirmed the
PlusCode programming number using
OK
L
.
TV channels will be
deactivated in the
GUIDE Plus+
®
System
after 24 hours
b
This happens occasionally. To switch on the channels proceed as follows:
1
Press
GUIDE/TV
J
.
2
Press
A
I
.
3
Select '
Editor
' using
C
M
.
4
Select the TV channel using
B
O
or
A
I
.
5
Press
D
K
to select the left row.
6
Switch on the TV channel using the red function button
D
.
7
End with
GUIDE/TV
J
.
No 'VPS/PDC time' in
the GUIDE Plus+
®
System
b
The GUIDE Plus+
®
System just shows the start time. The 'VPS/PDC' time will be taken into account.
There is no channel
overview in the GUIDE
Plus+
®
system
b
DVD recorder is switched on: Switch off the DVD recorder to allow data transfer
b
The TV channel that transmits the GUIDE Plus+
®
data is not set properly.
b
External receiver (satellite receiver, set-top box, cable TV box, ...) (if available) is switched off: switch on the
external receiver
b
G-LINK cable is not connected: Connect the G-LINK cable and make the necessary settings to control the
external receiver (see chapter 'The GUIDE Plus+
®
System', section 'Installation of the '
External receiver
1
').
b
Check that your external receiver (if available) sends out teletext data through the scartcable.
Connect therefore the scartcable from the external receiver directly to the TV set and call up the teletext
function on the TV set from a TV channel that transmits teletext data. If no teletext appears, your external
receiver can not be used for the GUIDE Plus+
®
system.
Missing or wrong TV
channelin the '
Grid
'
screen
b
Wrong local post code/country was entered
b
Please check your correct channel line up in the '
Grid
' screen.
Read therefore the section 'The '
Editor
' screen.
When you press
GUIDE/TV
J
the
GUIDE Plus+
®
setup
screen will appear
b
The GUIDE Plus+
®
system was not completely installed or local post code was not entered.
1
Check the settings
2
Select the corresponding line using
B
O
or
A
I
and confirm with
OK
L
.
3
For more information on the individual functions, see chapter 'The GUIDE Plus+
®
system',
section 'Setting up the GUIDE Plus+
®
System'.
Before you call an engineer